Assembly instructions for 1-sided fitting room - item no. 2007

Item no.: 2007

Before you begin
Lay out all parts so you have a clear overview of what is included.
2 pcs. Posts
2 pcs. Intermediate tubes
1 pc. Curtain rod
1 pc. Wall flange
1 pc. Curtain
12 pcs. Curtain rings
1 pc. Melamine board
2 pcs. Adjustable feet (a)
2 pcs. End caps (b)
5 pcs. Allen bolts for posts (c)
4 pcs. Screws for melamine board (d)
1 pc. Allen key (e)

Not included:
Screws for wall mounting – as these depend on the wall type and chosen mounting method.

Assembly of fitting-room wall (single wall)

🔸Fit the end caps (b) to the top of the two square tubes/posts.
🔸Install the adjustable feet (a) at the bottom of the posts.
🔸Attach the two intermediate tubes to one post.
🔸Mount the post with intermediate tubes to the wall at a suitable distance from the back wall
    (the other wall of the fitting room).
🔸Attach the other post to the intermediate tubes to form a stable frame.

Install the curtain rod in the outer post – pointing toward the wall that forms the opposite side of the fitting room.

🔸Fasten the wall flange to the wall at the same height so the curtain rod is level.
    (Remember to place the curtain rings on the rod before completing the curtain rod installation!)
🔸Install the melamine board in the frame – secure with 2x2 screws (d) through the intermediate tubes.
🔸Hang the curtain on the curtain rings.

Tip: Use the gathering tape if you want extra pleats in the curtain.
Steam the curtain with a steamer for a neat drape.

Assembly of 1 fitting-room wall and 2 curtain rods (one wall and two rods)

🔸Install two curtain rods in the middle post with a threaded rod.

For this configuration you must additionally purchase a threaded coupling, an extra curtain rod, a wall flange, curtain(s), and hooks.